Skip to content

Additional nRF52 bootloader previews

Download the matching MeshCore firmware for your exact board, role, and sensor variant. These same firmware images are also included in the 1.18.0.2 release. The bundled bootloader remains a preview.

OTAFIX 2.4.13-preview.1 has exact-board images for Heltec Mesh Solar, LilyGo T-Echo Card and T-Impulse Plus, Seeed MeshTracker X1, Nano G2 Ultra, and Muzi Base Uno and Duo. The two Muzi models use the same bootloader image. These builds passed software checks; they have not been tested on those physical devices by this project.

Repeater and Room firmware variants labelled with-bootloader-2.4.13-preview.1 carry the matching bootloader. After startup they check once for a compatible installed bootloader and update a recognized older one. They preserve the ordinary firmware variants, and the exact-board and flash-layout checks remain in force. An update can require SWD recovery if power is lost or hardware behavior differs from the board sources.

The automatic check recognizes specific published factory images for Solar, T-Echo Card, T-Impulse Plus, X1, and Nano G2 Ultra. It does not recognize every possible factory revision. A matching factory bootloader hash has not been established for Muzi Base, so its stock bootloader is not automatically replaced. An unrecognized or recovery bootloader is left untouched; the separate preview files and board-specific recovery route are still available. Use ota bootloader embedded status and get bootloader.ver to check the result on a compatible firmware build.

For Muzi Base Uno and Duo, the manufacturer's published bootloader source supports the separate update-muzi_base_bootloader-..._mbr.uf2 updater. To try it, double-reset to show the muzi-Base USB drive, copy the exact Muzi updater from the OTAFIX preview release, and let it finish. Then reinstall the matching MeshCore firmware UF2 if needed. This route has not been physically tested on these boards; it may require an application reinstall, and a failed bootloader update can require SWD recovery.

ThinkNode M4, ThinkNode M8, and Wio WM1110 Dev Kit are not covered by these images. Their board-specific bootloader identity or recovery path remains unresolved. Do not substitute a bootloader intended for another board.